Gas Blower

Step 1: Get the Blower Ready for Maintenance
Turn the blower off and make sure all moving parts are stopped. Remove the spark plug cover or boot and wire from the end of the spark plug. Follow any additional pre-maintenance procedures the manufacturer specifies.

Step 2: Clean the Blower
Brush off the blower, paying attention to air vents, cooling fins and flywheel blades.

Step 3: Inspect the Blower
Check the blower for any damage and loose or missing parts. Tighten loose fasteners and replace any missing or damaged parts before using the blower.

Step 4: Check the Air Filter
Clean or replace the air filter as needed. Some can be cleaned with soapy water and reinstalled once dry, but some aren't suitable for cleaning with water. Check your manual for the cleaning procedure.

Step 5: Check the Spark Plug
Clean the area around the spark plug. Use a spark plug wrench or ratchet and spark plug socket to loosen and remove the spark plug. Clean the spark plug if it's dirty, but you'll need to replace it with a new plug if it's worn or damaged. Check the gap distance on the end of the spark plug with a spark plug gap tool or feeler gauge and adjust as needed according to the manufacturer's specifications. Reinstall the spark plug and tighten it until it's snug. Don't overtighten the plug.

Step 6: Reconnect the Spark Plug
Reconnect the spark plug cover or boot and wire.

Step 7: Perform Monthly Maintenance
· Replace the fuel filter (if equipped).
· Clean the outside of the carburetor and fan blades.
· Examine the fuel line, fuel filter, cables and connections.
· Check the spark plug and replace it if needed.